Saltar al contenido principal
Ayuda

MacBook Core 2 Duo C-Channel Replacement

  • Autor: iRobot
  • Dificultad: Difícil

The metal support beneath the display.

Secciones

Paso 1 C-Channel  ¶ 

Remove the following 3 screws:

Paso 1 C-Channel  ¶ 

  • Remove the following 3 screws:

  • Two 3 mm Phillips near the right speaker.

  • One 6 mm Phillips threaded through a hole in a plastic finger above the subwoofer.

  • Be careful not to over-tighten the screw above the subwoofer too tight or the plastic could crack.

  • Santa Rosa and Penryn MacBooks do not have a c-channel. If you are disassembling either of these models, remove only the single 3 mm Phillips screw from the right speaker and skip step 26.

Paso 2  ¶ 

Lift the right speaker out of its housing and set it to the side.

Paso 2  ¶ 

  • Lift the right speaker out of its housing and set it to the side.

Paso 3  ¶ 

If you have a Santa Rosa/Penryn model, skip this step.

Paso 3  ¶ 

  • If you have a Santa Rosa/Penryn model, skip this step.

  • Using a spudger, gently pry up the white plastic slot and slide the metal c-channel to the right and away from the display.