Saltar al contenido principal
Ayuda

MacBook Pro 13" Unibody Early 2011 AirPort/Bluetooth Board Replacement

Replace the AirPort and Bluetooth board on your Early 2011 MacBook Pro 13" Unibody.

  • Autor: Andrew Bookholt
  • Tiempo estimado: 20 - 30 minutos
  • Dificultad: Moderar

Use this guide to replace a broken AirPort/Bluetooth board.

Paso 1 AirPort/Bluetooth Board  ¶ 

Peel back the piece of EMI tape covering the AirPort/Bluetooth cable connector.

Paso 1 AirPort/Bluetooth Board  ¶ 

  • Peel back the piece of EMI tape covering the AirPort/Bluetooth cable connector.

Paso 2  ¶ 

Use the tip of a spudger to lift the AirPort/Bluetooth cable connector out of its socket on the AirPort/Bluetooth board. Remove the AirPort/Bluetooth cable.

Paso 2  ¶ 

  • Use the tip of a spudger to lift the AirPort/Bluetooth cable connector out of its socket on the AirPort/Bluetooth board.

  • Remove the AirPort/Bluetooth cable.

Paso 3  ¶ 

Continue peeling the EMI tape off the bottom of the AirPort/Bluetooth bracket and remove it from the assembly.

Paso 3  ¶ 

  • Continue peeling the EMI tape off the bottom of the AirPort/Bluetooth bracket and remove it from the assembly.

Paso 4  ¶ 

Remove the three 3 mm Phillips screws securing the AirPort/Bluetooth board to its bracket.

Paso 4  ¶ 

  • Remove the three 3 mm Phillips screws securing the AirPort/Bluetooth board to its bracket.

Paso 5  ¶ 

Remove the AirPort/Bluetooth board from its bracket.

Paso 5  ¶ 

  • Remove the AirPort/Bluetooth board from its bracket.

  • Be careful not to damage the pink thermal pad attached to the bracket.