Saltar al contenido principal
Ayuda

MacBook Pro 15" Core Duo Model A1150 Display Assembly Replacement

Guía Destacada

Guía Destacada

Esta guía ha sido valorada como excepcionalmente genial por el personal de iFixit.

Use this guide to replace the display assembly.

  • Autor: iRobot
  • Tiempo estimado: 45 minutos - 3 horas
  • Dificultad: Moderar

Change out the entire display assembly, including the inverter, Airport antennas, hinges and casing.

Paso 1 Display Assembly  ¶ 

Disconnect the two antenna cables attached to the Airport Extreme card.

Paso 1 Display Assembly  ¶ 

  • Disconnect the two antenna cables attached to the Airport Extreme card.

  • The white antenna cable connects to the left side of the Airport Extreme card.

Paso 2  ¶ 

Deroute the Airport antenna cables from their channel in the left speaker.

Paso 2  ¶ 

  • Deroute the Airport antenna cables from their channel in the left speaker.

Paso 3  ¶ 

Disconnect the iSight, inverter, and left fan cables from the logic board by gently pulling in the direction of each cable.

Paso 3  ¶ 

  • Disconnect the iSight, inverter, and left fan cables from the logic board by gently pulling in the direction of each cable.

Paso 4  ¶ 

Disconnect the display data cable from the logic board.

Paso 4  ¶ 

  • Disconnect the display data cable from the logic board.

Paso 5  ¶ 

Remove the silver T6 Torx screw securing the ground loop on the display data cable to the casing.

Paso 5  ¶ 

  • Remove the silver T6 Torx screw securing the ground loop on the display data cable to the casing.

Paso 6  ¶ 

Support the display with one hand while removing the following 3 screws:

Paso 6  ¶ 

  • Support the display with one hand while removing the following 3 screws:

  • Two 9.5 mm silver T6 Torx screws with threads on only part of the shaft on the inside of the display hinges.

  • One 9.5 mm silver T6 Torx screw with threads on the entire shaft on the outside of the left hinge.

Paso 7  ¶ 

Grasp the display assembly on both sides and lift it up and out of the computer.

Paso 7  ¶ 

  • Grasp the display assembly on both sides and lift it up and out of the computer.