Saltar al contenido principal
Ayuda

iPod 1st Generation Battery Replacement

Guía Destacada

Guía Destacada

Esta guía ha sido valorada como excepcionalmente genial por el personal de iFixit.

  • Autor: iRobot
  • Tiempo estimado: 15 - 40 minutos
  • Dificultad: Moderar

Battery not lasting long? Swap it out.

Secciones
Herramientas
Partes Pertinentes

Paso 1 Battery  ¶ 

Lift the battery up from the adhesive holding it to the iPod.

Paso 1 Battery  ¶ 

  • Lift the battery up from the adhesive holding it to the iPod.

  • Lay the battery next to the iPod (it is still connected to the logic board).

Paso 2  ¶ 

Lift up the end of the hard drive near the Firewire port to allow easy access to the battery connector.

Paso 2  ¶ 

  • Lift up the end of the hard drive near the Firewire port to allow easy access to the battery connector.

Paso 3  ¶ 

Carefully disconnect the white battery connector from the logic board. Be sure to pull only on the connector itself and not on the cables.

Paso 3  ¶ 

  • Carefully disconnect the white battery connector from the logic board. Be sure to pull only on the connector itself and not on the cables.