Saltar al contenido principal
Ayuda

Nintendo Wii DVD Drive Replacement

Sólo Prerrequisito

Sólo Prerrequisito

Por favor, ten en cuenta que esta guía es sólo un prerrequisito para otras guías.

Replace the internal DVD drive on your Wii.

  • Autor: Andrew Bookholt
  • Tiempo estimado: 35 minutos - 2 horas
  • Dificultad: Moderar

Use this guide to replace a broken DVD drive.

Secciones
Herramientas

Paso 1 DVD Drive  ¶ 

Remove the small Phillips screw securing the battery door to the bottom panel. This screw is captive to the battery door.

Paso 1 DVD Drive  ¶ 

  • Remove the small Phillips screw securing the battery door to the bottom panel.

  • This screw is captive to the battery door.

  • Pull the battery door out of the Wii.

  • This is a good time to change the CR2032 battery if it hasn't been changed recently.

Paso 2  ¶ 

Remove the 8.2 mm Tri-Wing screw that was hidden beneath the battery door.

Paso 2  ¶ 

  • Remove the 8.2 mm Tri-Wing screw that was hidden beneath the battery door.

Paso 3  ¶ 

Remove the two 8.2 mm Tri-Wing screws securing the DVD drive shield near the controller ports.

Paso 3  ¶ 

  • Remove the two 8.2 mm Tri-Wing screws securing the DVD drive shield near the controller ports.

Paso 4  ¶ 

Lift the DVD drive shield upward and remove it from the Wii.

Paso 4  ¶ 

  • Lift the DVD drive shield upward and remove it from the Wii.

Paso 5  ¶ 

Remove the four 9 mm Phillips screws securing the DVD drive to the bottom panel.

Paso 5  ¶ 

  • Remove the four 9 mm Phillips screws securing the DVD drive to the bottom panel.

Paso 6  ¶ 

Lift the side of the DVD drive opposite the controller ports enough to access the cables on its bottom face.

Paso 6  ¶ 

  • Lift the side of the DVD drive opposite the controller ports enough to access the cables on its bottom face.

  • Carefully pull the DVD drive power cable out from under the plastic shroud near the heat sink.

Paso 7  ¶ 

Pull the DVD drive power cable away from its socket on the DVD drive.

Paso 7  ¶ 

  • Pull the DVD drive power cable away from its socket on the DVD drive.

Paso 8  ¶ 

Use your fingernail to flip up the retaining flap on the DVD drive ribbon cable socket. Be sure you are prying up on the retaining flap, not the socket itself.

Paso 8  ¶ 

  • Use your fingernail to flip up the retaining flap on the DVD drive ribbon cable socket.

  • Be sure you are prying up on the retaining flap, not the socket itself.

  • Pull the DVD drive ribbon cable out of its socket.

  • Remove the DVD drive from the Wii.