Saltar al contenido principal
Ayuda

Mac mini Mid 2010 Antenna Plate Replacement

Removing the perforated steel antenna plate.

Use this guide to replace the antenna plate that serves as a mount for the antenna as well as the hard drive.

Secciones

Paso 1 Antenna Plate  ¶ 

Remove the following screws securing the antenna plate to the mini:

Paso 1 Antenna Plate  ¶ 

  • Remove the following screws securing the antenna plate to the mini:

  • Two 6.6 mm T8 Torx screws

  • Two 5.0 mm T8 Torx or 2.0 mm Hex screws (either will work)

Paso 2  ¶ 

Slightly lift the antenna plate from the end closest to the RAM. Carefully pull the antenna plate straight away from the circular rim of the outer case.

Paso 2  ¶ 

  • Slightly lift the antenna plate from the end closest to the RAM.

  • Carefully pull the antenna plate straight away from the circular rim of the outer case.

  • Do not remove the antenna plate yet. It is still attached to the AirPort/ Bluetooth board.

Paso 3  ¶ 

Use the tip of a spudger to carefully pry the antenna connector up off the AirPort/Bluetooth board.

Paso 3  ¶ 

  • Use the tip of a spudger to carefully pry the antenna connector up off the AirPort/Bluetooth board.

Paso 4  ¶ 

Remove the antenna plate from the mini.

Paso 4  ¶ 

  • Remove the antenna plate from the mini.