Saltar al contenido principal
Ayuda

MacBook Core Duo Display Replacement

Guía Destacada

Guía Destacada

Esta guía ha sido valorada como excepcionalmente genial por el personal de iFixit.

MacBook Core display assembly replacement.

  • Autor: iRobot
  • Tiempo estimado: 30 minutos - 2 horas
  • Dificultad: Difícil

Change out the entire display assembly, including the inverter, Airport antennas, hinges and casing. While more costly than a simply LCD replacement, there is a huge savings in time and effort required.

Secciones
Herramientas
Herramientas (continuación)
Partes Pertinentes

Paso 1 Display  ¶ 

Use a spudger to carefully disconnect the microphone cable from the logic board. You'll want to work from side to side, and slowly wiggle the connector out of its socket.

Paso 1 Display  ¶ 

  • Use a spudger to carefully disconnect the microphone cable from the logic board. You'll want to work from side to side, and slowly wiggle the connector out of its socket.

  • Pulling on this connector vertically will break the socket off the logic board. This connector should be removed horizontally by gently pulling the microphone cable toward the screen while working a spudger between the connector and the socket.

Paso 2  ¶ 

Lift up on the black right speaker cable with one hand, and deroute the silver microphone cable from the silver metal clip just above the right RAM slot.

Paso 2  ¶ 

  • Lift up on the black right speaker cable with one hand, and deroute the silver microphone cable from the silver metal clip just above the right RAM slot.

Paso 3  ¶ 

Deroute the silver microphone cable and gray display data cable from the tabs at the bottom of the subwoofer.

Paso 3  ¶ 

  • Deroute the silver microphone cable and gray display data cable from the tabs at the bottom of the subwoofer.

Paso 4  ¶ 

Remove the single 3.2 mm Phillips screw securing the ground loop in the display data cable located just above the Bluetooth board.

Paso 4  ¶ 

  • Remove the single 3.2 mm Phillips screw securing the ground loop in the display data cable located just above the Bluetooth board.

Paso 5  ¶ 

Disconnect the two antenna cables from the Airport card, and the black inverter cable from the logic board. (Pull vertically on all three.)

Paso 5  ¶ 

  • Disconnect the two antenna cables from the Airport card, and the black inverter cable from the logic board. (Pull vertically on all three.)

Paso 6  ¶ 

Remove the following 2 screws from the right hinge mount:

Paso 6  ¶ 

  • Remove the following 2 screws from the right hinge mount:

  • One 6 mm Phillips on the left side of the hinge mount.

  • One 10 mm Phillips on the right side of the hinge mount.

  • Lift the right hinge mount out of the computer.

Paso 7  ¶ 

Hold the display with one hand while removing the screws from the left hinge mount.

Paso 7  ¶ 

  • Hold the display with one hand while removing the screws from the left hinge mount.

  • Remove the following 3 screws from the left hinge mount:

  • One 6 mm smaller diameter Phillips from the right side.

  • One 6 mm larger diameter Phillips from the middle.

  • One 10 mm Phillips from the left side.

  • Lift the left hinge mount out of the computer.

Paso 8  ¶ 

Grasp the display assembly on either side, and lift it up and out of the computer.

Paso 8  ¶ 

  • Grasp the display assembly on either side, and lift it up and out of the computer.