Saltar al contenido principal
Ayuda

MacBook Pro 15" Unibody Mid 2010 Hard Drive/IR Sensor Cable Replacement

Replace the hard drive/IR sensor cable on your MacBook Pro 15" Unibody Mid 2010.

The hard drive cable also contains the IR sensor/sleep indicator.

Paso 1 Hard Drive/IR Sensor Cable  ¶ 

Use the flat end of a spudger to pry the hard drive cable connector up off the logic board.

Paso 1 Hard Drive/IR Sensor Cable  ¶ 

  • Use the flat end of a spudger to pry the hard drive cable connector up off the logic board.

Paso 2  ¶ 

Remove the following four screws securing the hard drive and IR sensor cable to the upper case:

Paso 2  ¶ 

  • Remove the following four screws securing the hard drive and IR sensor cable to the upper case:

  • Two 1.5 mm Phillips screws.

  • Two 4 mm Phillips screws.

Paso 3  ¶ 

Slide the hard drive and IR sensor bracket away from the edge of the upper case. Carefully peel the hard drive and IR sensor cable from the upper case.

Paso 3  ¶ 

  • Slide the hard drive and IR sensor bracket away from the edge of the upper case.

  • Carefully peel the hard drive and IR sensor cable from the upper case.

  • Lift the hard drive and IR sensor assembly out of the upper case.