Saltar al contenido principal
Ayuda

iPhone 6 Plus Logic Board Replacement

Replace the Logic Board in the iPhone 6 Plus.

  • Autor: Jeff Suovanen
  • Tiempo estimado: 40 minutos - 2 horas
  • Dificultad: Moderar

Use this guide to replace the logic board in your iPhone 6s Plus.

It's important to note that each iPhone's logic board and Touch ID fingerprint sensor are paired at the factory, so replacing the logic board will disable Touch ID unless you also install a replacement home button that has been properly paired to your new logic board.

Paso 1 Logic Board  ¶ 

Remove the following screws securing the logic board to the rear case:

Paso 1 Logic Board  ¶ 

  • Remove the following screws securing the logic board to the rear case:

  • Two 2.4 mm standoff screws

  • Standoff screws are best removed with a standoff screwdriver or standoff driver bit. A small flathead screwdriver can also do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

  • One 2.1 mm Phillips #00 screw

Paso 2  ¶ 

Carefully raise—but do not remove—the logic board, lifting it from the bottom edge nearest the Lightning connector.

Paso 2  ¶ 

  • Carefully raise—but do not remove—the logic board, lifting it from the bottom edge nearest the Lightning connector.

Paso 3  ¶ 

Do not remove the logic board. At this point it is still tethered to the rear case via an antenna connector.

Paso 3  ¶ 

  • Do not remove the logic board. At this point it is still tethered to the rear case via an antenna connector.

  • Continue carefully lifting the bottom side of the logic board until it is vertical.

Paso 4  ¶ 

Gently lay the logic board upside-down, with the top portion resting against the rear case of the iPhone. Use the flat end of a spudger to disconnect the antenna connector from its socket on the back of the logic board.

Paso 4  ¶ 

  • Gently lay the logic board upside-down, with the top portion resting against the rear case of the iPhone.

  • Use the flat end of a spudger to disconnect the antenna connector from its socket on the back of the logic board.

Paso 5  ¶ 

Lift and remove the logic board out of the iPhone.

Paso 5  ¶ 

  • Lift and remove the logic board out of the iPhone.