Saltar al contenido principal
Ayuda

Sanyo VPC S1275 Case Replacement

  • Autor: Ariana Martinez
  • Tiempo estimado: 10 - 15 minutos
  • Dificultad: Fácil

Use this guide to remove or replace the case.

Secciones
Herramientas

Paso 1 Case  ¶ 

Unscrew 6 Phillips screws using the #00 Phillips screwdriver. Two screws are on the left side of the camera. Two screws are on the right side of the camera.

Paso 1 Case  ¶ 

  • Unscrew 6 Phillips screws using the #00 Phillips screwdriver.

  • Two screws are on the left side of the camera.

  • Two screws are on the right side of the camera.

  • Two screws are on the bottom of the camera.

Paso 2  ¶ 

Open battery slot on the bottom of the camera by sliding the door to the right. Remove the 4 mm phillips screw on the bottom right using the #00 phillips screwdriver.

Paso 2  ¶ 

  • Open battery slot on the bottom of the camera by sliding the door to the right.

  • Remove the 4 mm phillips screw on the bottom right using the #00 phillips screwdriver.

Paso 3  ¶ 

Insert spudger in the seam at the bottom of the camera. Gently separate the rear case from the front of the camera. Gently separate the rear case from the front of the camera.

Paso 3  ¶ 

  • Insert spudger in the seam at the bottom of the camera.

  • Gently separate the rear case from the front of the camera.

Paso 4  ¶ 

This step is only needed for the case and logic board replacement

Paso 4  ¶ 

  • This step is only needed for the case and logic board replacement

  • Using the #00 phillips screwdriver remove the screw attached to the front casing in the top left corner. Front case should easily separate.

Paso 5  ¶ 

This step is only needed for the case replacement.

Paso 5  ¶ 

  • This step is only needed for the case replacement.

  • Using the #00 phillips screwdriver remove the screw on the inside of the battery door.

  • Slide the battery door off of the hinge.