Saltar al contenido principal
Ayuda

PowerBook G4 Aluminum 15" 1-1.5 GHz Hard Drive Replacement

Guía Destacada

Guía Destacada

Esta guía ha sido valorada como excepcionalmente genial por el personal de iFixit.

  • Autor: iRobot
  • Dificultad: Difícil

You can install hard drives up to 12.5mm thick.

Paso 1 Hard Drive  ¶ 

Your hard drive should look approximately like this.

Paso 1 Hard Drive  ¶ 

  • Your hard drive should look approximately like this.

Paso 2  ¶ 

Remove the two silver Phillips screws and black rubber bumpers from either side of the hard drive (four sets of screws and bumpers total).

Paso 2  ¶ 

  • Remove the two silver Phillips screws and black rubber bumpers from either side of the hard drive (four sets of screws and bumpers total).

  • Lift the plastic shield off of the hard drive.

Paso 3  ¶ 

Disconnect the hard drive cable from the hard drive by applying even pressure on both sides while maintaining a firm grip on the drive itself.

Paso 3  ¶ 

  • Disconnect the hard drive cable from the hard drive by applying even pressure on both sides while maintaining a firm grip on the drive itself.

  • This is a bit tricky. Try holding the drive against your body while pushing the cable away from you, or rocking the cable gently from side to side while applying even pressure, or both. If you bend the pins, do your best to straighten them, using the hard drive cable as a guide.

  • If you are installing a new hard drive, we have an OS X install guide to get you up and running.