Saltar al contenido principal
Ayuda

iPad Wi-Fi Dock Connector Cable Replacement

Replace a broken dock connector cable on your iPad Wi-Fi.

Use this guide to replace your iPad's dock connector cable.

Paso 1 Dock Connector Cable  ¶ 

Remove the two 4.56 mm T5 Torx screws securing the dock connector cable to the main board.

Paso 1 Dock Connector Cable  ¶ 

  • Remove the two 4.56 mm T5 Torx screws securing the dock connector cable to the main board.

Paso 2  ¶ 

Remove the single 2.84 mm T5 Torx screw connecting the dock connector cable to the rear case assembly.

Paso 2  ¶ 

  • Remove the single 2.84 mm T5 Torx screw connecting the dock connector cable to the rear case assembly.

Paso 3  ¶ 

Remove the two 2.84 mm T5 Torx screws securing the dock connector cable to the rear panel assembly.

Paso 3  ¶ 

  • Remove the two 2.84 mm T5 Torx screws securing the dock connector cable to the rear panel assembly.

Paso 4  ¶ 

Carefully remove the plastic cover over the WiFi/Bluetooth board and dock connector cable using a plastic opening tool.

Paso 4  ¶ 

  • Carefully remove the plastic cover over the WiFi/Bluetooth board and dock connector cable using a plastic opening tool.

Paso 5  ¶ 

Pry the Wi-Fi and Bluetooth antennas up off their respective sockets on the Wi-Fi/Bluetooth board.

Paso 5  ¶ 

  • Pry the Wi-Fi and Bluetooth antennas up off their respective sockets on the Wi-Fi/Bluetooth board.

  • Remove the dock connector cable from the rear panel assembly.