Saltar al contenido principal
Ayuda

PowerBook G4 Aluminum 12" 1-1.5 GHz Clutch Cover Replacement

Use this guide to replace your clutch cover

Paso 1 Clutch Cover  ¶ 

Flip the device over and remove the two 4.5 mm Phillips screws on each side of the metal bracket (four screws in total). Thread the display inverter, antenna, and display data cables through the bracket and remove the metal bracket.

Paso 1 Clutch Cover  ¶ 

  • Flip the device over and remove the two 4.5 mm Phillips screws on each side of the metal bracket (four screws in total).

  • Thread the display inverter, antenna, and display data cables through the bracket and remove the metal bracket.

Paso 2  ¶ 

Flip the device over.

Paso 2  ¶ 

  • Flip the device over.

  • Remove the 5.5 mm Phillips screw connecting the display inverter to the front display bezel.

Paso 3  ¶ 

The inverter is an extremely thin circuit board that is very delicate and easily cracked. Take care when handling.

Paso 3  ¶ 

  • The inverter is an extremely thin circuit board that is very delicate and easily cracked. Take care when handling.

  • Using the pointed end of a spudger, lift the display inverter out of the clutch cover.

Paso 4  ¶ 

Remove the three 3.0 mm Phillips screws connecting the clutch cover to the front display bezel.

Paso 4  ¶ 

  • Remove the three 3.0 mm Phillips screws connecting the clutch cover to the front display bezel.

Paso 5  ¶ 

Pull the left edge of the clutch cover downwards. Pull the left edge of the clutch cover downwards.

Paso 5  ¶ 

  • Pull the left edge of the clutch cover downwards.

Paso 6  ¶ 

Pull the right edge of the clutch cover downwards. Remove the clutch cover from the device.

Paso 6  ¶ 

  • Pull the right edge of the clutch cover downwards.

  • Remove the clutch cover from the device.