Saltar al contenido principal
Ayuda

MacBook Unibody Model A1342 Rear Speaker Assembly Replacement

Sólo Prerrequisito

Sólo Prerrequisito

Por favor, ten en cuenta que esta guía es sólo un prerrequisito para otras guías.

This guide is an internal private guide used as a prereq.

Paso 1 Rear Speaker Assembly  ¶ 

Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off the logic board.

Paso 1 Rear Speaker Assembly  ¶ 

  • Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off the logic board.

Paso 2  ¶ 

Remove the following screws securing the right speaker assembly to the upper case:

Paso 2  ¶ 

  • Remove the following screws securing the right speaker assembly to the upper case:

  • One 12 mm Phillips screw.

  • One 3 mm Phillips screw.

Paso 3  ¶ 

Remove the single 2.2 mm Phillips screw inserted horizontally into the side of the optical drive.

Paso 3  ¶ 

  • Remove the single 2.2 mm Phillips screw inserted horizontally into the side of the optical drive.

Paso 4  ¶ 

Pry the AirPort and Bluetooth antenna connectors (3 total) up off the AirPort/Bluetooth card. De-route the long antenna from its channel in the rear speaker housing.

Paso 4  ¶ 

  • Pry the AirPort and Bluetooth antenna connectors (3 total) up off the AirPort/Bluetooth card.

  • De-route the long antenna from its channel in the rear speaker housing.

Paso 5  ¶ 

Use the flat end of a spudger to pry the rear speaker cable connector up off the logic board.

Paso 5  ¶ 

  • Use the flat end of a spudger to pry the rear speaker cable connector up off the logic board.

Paso 6  ¶ 

Remove the rear speaker assembly from the upper case.

Paso 6  ¶ 

  • Remove the rear speaker assembly from the upper case.

Paso 7  ¶ 

Carefully peel the AirPort/Bluetooth cable from its channel within the rear speaker assembly. Use the flat end of a spudger to pry the AirPort/Bluetooth cable up off the rear speaker.

Paso 7  ¶ 

  • Carefully peel the AirPort/Bluetooth cable from its channel within the rear speaker assembly.

  • Use the flat end of a spudger to pry the AirPort/Bluetooth cable up off the rear speaker.

Paso 8  ¶ 

Remove three 3 mm Phillips screws securing the AirPort/Bluetooth board to the rear speaker assembly.

Paso 8  ¶ 

  • Remove three 3 mm Phillips screws securing the AirPort/Bluetooth board to the rear speaker assembly.

Paso 9  ¶ 

Lift the AirPort/Bluetooth board up off the rear speaker assembly.

Paso 9  ¶ 

  • Lift the AirPort/Bluetooth board up off the rear speaker assembly.