Saltar al contenido principal
Ayuda

MacBook Pro 15" Unibody 2.53 GHz Mid 2009 Hard Drive/IR Sensor Cable Replacement

The hard drive cable also contains the IR sensor/sleep indicator.

Paso 1 Hard Drive/IR Sensor Cable  ¶ 

Remove the following four screws securing the hard drive and IR sensor cable to the upper case:

Paso 1 Hard Drive/IR Sensor Cable  ¶ 

  • Remove the following four screws securing the hard drive and IR sensor cable to the upper case:

  • Two 1.5 mm Phillips screws.

  • Two 4 mm Phillips screws.

Paso 2  ¶ 

Slide the hard drive and IR sensor bracket away from the edge of the upper case. Carefully peel the hard drive and IR sensor cable from the upper case.

Paso 2  ¶ 

  • Slide the hard drive and IR sensor bracket away from the edge of the upper case.

  • Carefully peel the hard drive and IR sensor cable from the upper case.

Paso 3  ¶ 

Use the flat end of a spudger to pry the hard drive cable connector up off the logic board.

Paso 3  ¶ 

  • Use the flat end of a spudger to pry the hard drive cable connector up off the logic board.

  • Lift the hard drive and IR sensor assembly out of the upper case.

Paso 4  ¶ 

Your replacement part may or may not come with the front (sensor) bracket. If it does not, you'll need to transfer it to your new cable. Use the tip of a spudger to flip the ZIF connector on the hard drive cable. Gently pull the sensor bracket cable out of the ZIF connector.

Paso 4  ¶ 

  • Your replacement part may or may not come with the front (sensor) bracket. If it does not, you'll need to transfer it to your new cable.

  • Use the tip of a spudger to flip the ZIF connector on the hard drive cable.

  • Gently pull the sensor bracket cable out of the ZIF connector.

  • Use the flat end of a spudger to pry the hard drive cable up off the sensor bracket.

  • Remove the adhesive backing from your new hard drive cable, stick it onto the sensor bracket, and connect the sensor bracket cable.