Saltar al contenido principal
Ayuda

iBook G3 14" Keyboard Replacement

  • Autor: iRobot
  • Dificultad: Fácil

Replacing this keyboard is easy and takes only a few minutes.

Secciones
Archivos
Herramientas

Paso 1 Keyboard  ¶ 

Pull the keyboard release tabs (highlighted in red) toward you and lift up on the keyboard until it pops free.

Paso 1 Keyboard  ¶ 

  • Pull the keyboard release tabs (highlighted in red) toward you and lift up on the keyboard until it pops free.

  • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

  • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

Paso 2  ¶ 

If your computer does not have an AirPort card installed, skip to the RAM shield removal step.

Paso 2  ¶ 

  • If your computer does not have an AirPort card installed, skip to the RAM shield removal step.

  • Push the wire clasp toward the AirPort card and pull it up to free it from the RAM shield.

Paso 3  ¶ 

Grasp the clear plastic tab on the AirPort card and pull toward the right.

Paso 3  ¶ 

  • Grasp the clear plastic tab on the AirPort card and pull toward the right.

Paso 4  ¶ 

Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

Paso 4  ¶ 

  • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

Paso 5  ¶ 

Remove the two Phillips screws that secure the RAM shield.

Paso 5  ¶ 

  • Remove the two Phillips screws that secure the RAM shield.

Paso 6  ¶ 

Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

Paso 6  ¶ 

  • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

Paso 7  ¶ 

Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

Paso 7  ¶ 

  • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.