iPad 2 Wi-Fi EMC 2560 Front Panel Adhesive Strips Replacement
Replace the front panel adhesive in your iPad 2 Wi-Fi EMC 2560.
- Autor: Sam Lionheart
- Dificultad: Moderar
Use this guide to replace the adhesive on your iPad to seal the deal on a repair-job well done.
Before you begin peeling and sticking tape, it's important to have clean adhesion surfaces on both the front panel and the rear case. Use a spudger to scrape off any large excess bits of original adhesive, then clean all of the gluing surfaces with a paper towel and rubbing alcohol or Goof Off.
It is recommended that you peel each adhesive strip as needed, rather than lay them out all at once.
Incrustar esta guía
Elige un tamaño y copea el siguiente código para incrustar esta guía como un pequeño widget en tu sitio / foro.