Saltar al contenido principal
Ayuda

MacBook Pro 13" Unibody Mid 2009 Battery Replacement

Guía Destacada

Guía Destacada

Esta guía ha sido valorada como excepcionalmente genial por el personal de iFixit.

If your battery no longer holds a charge, use this guide to replace it.

  • Autor: Walter Galan
  • Tiempo estimado: 5 - 10 minutos
  • Dificultad: Fácil

Use this guide to replace an old or faulty battery and revitalize your MacBook Pro. If your battery is swollen, take appropriate precautions.

Paso 1 Battery  ¶ 

Remove the following tri-point screws securing the battery to the upper case:

Paso 1 Battery  ¶ 

  • Remove the following tri-point screws securing the battery to the upper case:

  • One 5.5 mm tri-point screw.

  • One 13.5 mm tri-point screw.

Paso 2  ¶ 

Use the flat end of a spudger to lift the battery connector up out of its socket on the logic board.

Paso 2  ¶ 

  • Use the flat end of a spudger to lift the battery connector up out of its socket on the logic board.

Paso 3  ¶ 

Lift the battery out of the upper case.

Paso 3  ¶ 

  • Lift the battery out of the upper case.

  • If you're installing a new battery, you should calibrate it after installation:

  • Charge it to 100%, and then keep charging it for at least 2 more hours. Next, unplug and use it normally to drain the battery. When you see the low battery warning, save your work, and keep your laptop on until it goes to sleep due to low battery. Wait at least 5 hours, then charge your laptop uninterrupted to 100%.

  • If you notice any unusual behavior or problems after installing your new battery, you may need to reset your MacBook's SMC.