OnePlus 5 Back Cover Replacement
Follow this guide to remove the back cover and access the OnePlus 5's internals.
- Autor: Arthur Shi
- Tiempo estimado: 20 minutos - 1 hora
- Dificultad: Moderar
This guide shows how to remove the back cover to access the OnePlus 5’s internals. The hardest part is getting the frame clips free. Once that is done, the cover comes off easily.
Incrustar esta guía
Elige un tamaño y copea el siguiente código para incrustar esta guía como un pequeño widget en tu sitio / foro.
Paso 1 — Back Cover ¶
Remove the two 2.6 mm T2 screws straddling the USB-C port on the bottom edge of the phone.
Paso 2 ¶
Display panel seam: This seam is part of the display assembly. Do not pry at this seam, or you will separate and damage the display panel.
Frame seam: This is where the plastic frame meets the back cover. Only pry at this seam.
There are twelve clips that hold the frame against the rear case. Be aware of their location as you pry the back cover off in the following steps.
Paso 3 ¶
Place a suction cup near the bottom edge of the display.
Pull on the suction cup with strong steady force.
Press the edge of an opening tool straight into the frame seam near the suction cup until the edge wedges between the plastic frame and the back cover's lip.
Paso 4 ¶
Once the opening tool's edge is wedged in position, carefully slide the tool along the bottom edge of the phone.
Carefully guide the opening tool around the left corner of the phone while keeping the tool's edge within the seam.
Paso 5 ¶
Lever the opening tool to release the first clip from the frame.
Paso 6 ¶
Continue sliding the opening tool along the long edge, releasing the clips along the way.
Paso 7 ¶
Paso 8 ¶
With all the clips released, flip the phone over so that the display is face-down.
Swing the back cover around and rest it on top of the exposed frame.
Paso 9 ¶
Remove the 2.6 mm Phillips screw holding the cable bracket above the battery in place.
Lift up and remove the cable bracket.
Paso 10 ¶
Use the point of a spudger to pry up and disconnect the back cover flex cable from its socket.
Paso 11 ¶
Remove the back cover.