Saltar al contenido principal
Ayuda

Mac mini Late 2018 Memory (RAM) Replacement

Guía Destacada

Guía Destacada

Esta guía ha sido valorada como excepcionalmente genial por el personal de iFixit.

Guía Contribuida Por Miembros

Guía Contribuida Por Miembros

Un miembro increíble de nuestra comunidad escribió esta guía. No está supervisada por el personal de iFixit.

How to upgrade the RAM in your shiny new 2018 Mac mini.

  • Autor: Rod Bland
  • Tiempo estimado: 20 - 40 minutos
  • Dificultad: Moderar

Learn how to upgrade or replace the memory in your 2018 Mac mini with this RAM replacement guide. The mini can support up to 64 GB of RAM, using any combination of 8 GB, 16 GB, or 32 GB DDR4-2666 SODIMM RAM modules.

Paso 1 RAM  ¶ 

Use a T5 Torx driver to remove the four 2.8 mm screws securing the RAM shield.

Paso 1 RAM  ¶ 

  • Use a T5 Torx driver to remove the four 2.8 mm screws securing the RAM shield.

Paso 2  ¶ 

Lift the RAM shield and slide it off of the RAM assembly.

Paso 2  ¶ 

  • Lift the RAM shield and slide it off of the RAM assembly.

Paso 3  ¶ 

Two clips secure each RAM module in place, one on each side. Using your fingers, spread the clips away from the RAM module. When released, the RAM modules will pop up at a slight angle.

Paso 3  ¶ 

  • Two clips secure each RAM module in place, one on each side. Using your fingers, spread the clips away from the RAM module.

  • When released, the RAM modules will pop up at a slight angle.

Paso 4  ¶ 

Slide each RAM module straight out to remove it.

Paso 4  ¶ 

  • Slide each RAM module straight out to remove it.

  • When handling the RAM modules, touch only the outside edges. Take care not to touch the gold-colored contact points along the bottom edge.

Paso 5  ¶ 

To install new RAM modules: Make sure the module is oriented correctly and the notch on the bottom is aligned, and then slide it in at about the same angle as you took it out. Press evenly until the gold contacts are no longer visible. Repeat for the second module.

Paso 5  ¶ 

  • To install new RAM modules:

  • Make sure the module is oriented correctly and the notch on the bottom is aligned, and then slide it in at about the same angle as you took it out. Press evenly until the gold contacts are no longer visible.

  • Repeat for the second module.

Paso 6  ¶ 

Finally, press the top edge of each RAM module to swing it down toward the logic board until the retaining clips on each side snap into place. If the rubber guards interfere with the clips, spread the rubber guards away from the RAM with one hand and use the other to angle the RAM modules into place. Then, release the guards. Check the clips and make sure both modules are fully seated and secure.

Paso 6  ¶ 

  • Finally, press the top edge of each RAM module to swing it down toward the logic board until the retaining clips on each side snap into place.

  • If the rubber guards interfere with the clips, spread the rubber guards away from the RAM with one hand and use the other to angle the RAM modules into place. Then, release the guards.

  • Check the clips and make sure both modules are fully seated and secure.