Saltar al contenido principal
Ayuda

Canon PowerShot SD30 Motherboard Replacement

This guide will explain how to remove the motherboard from your Canon PowerShot SD30.

  • Autor: Ime Ekpo
  • Tiempo estimado: 10 - 20 minutos
  • Dificultad: Moderar

Follow the steps in this guide to remove and replace the motherboard of the camera. Damage to the motherboard will cause other components to fail.

Paso 1 Motherboard  ¶ 

Unscrew the 3mm silver screw from the top of the camera. Gently remove the top button panel.

Paso 1 Motherboard  ¶ 

  • Unscrew the 3mm silver screw from the top of the camera.

  • Gently remove the top button panel.

Paso 2  ¶ 

Using the tweezers, carefully lift up the 2 folds where the ribbon connects to the motherboard. Now, lift up the three remaining ribbon connectors to disconnect them.

Paso 2  ¶ 

  • Using the tweezers, carefully lift up the 2 folds where the ribbon connects to the motherboard.

  • Now, lift up the three remaining ribbon connectors to disconnect them.

Paso 3  ¶ 

Unscrew the three 3mm silver screws from the motherboard.

Paso 3  ¶ 

  • Unscrew the three 3mm silver screws from the motherboard.

Paso 4  ¶ 

Gently pull the left wire out and disconnect it from the device. Use the tweezers to pop the right set of wires out of the connector. Do this by positioning the tweezers under the connector and lifting up. Use the tweezers to pop the right set of wires out of the connector. Do this by positioning the tweezers under the connector and lifting up.

Paso 4  ¶ 

  • Gently pull the left wire out and disconnect it from the device.

  • Use the tweezers to pop the right set of wires out of the connector. Do this by positioning the tweezers under the connector and lifting up.

Paso 5  ¶ 

Remove the motherboard from the device.

Paso 5  ¶ 

  • Remove the motherboard from the device.

  • The motherboard will have nothing connecting it to anything, so be sure to have it grasped.