Saltar al contenido principal
Ayuda

Insignia NS-F12R6-SS Motor Housing Replacing

Guía de Estudiante Destacada

Guía de Estudiante Destacada

Esta guía fue realizada gracias al duro trabajo de nuestros fantásticos estudiantes y ha sido valorada como excepcionalmente genial por el personal de iFixit.

This guide will show you how to remove the motor housing on your Insignia NS-F12R6-SS fan.

  • Autor: Hank
  • Tiempo estimado: 10 - 15 minutos
  • Dificultad: Moderar

Removing the motor housing provides access to all of the fan's internal workings.

Secciones

Paso 1 Motor Housing  ¶ 

Use your fingers to gently pull the power knob directly away from the motor housing.

Paso 1 Motor Housing  ¶ 

  • Use your fingers to gently pull the power knob directly away from the motor housing.

Paso 2  ¶ 

Unscrew the flat 17 mm nut fastened at the bottom of the power knob with a small crescent wrench.

Paso 2  ¶ 

  • Unscrew the flat 17 mm nut fastened at the bottom of the power knob with a small crescent wrench.

Paso 3  ¶ 

Remove the four 6 mm bolts and small washers that secure the front face of the motor housing with a Phillips #3 screwdriver and remove the washers. Remove the four 6 mm bolts and small washers that secure the front face of the motor housing with a Phillips #3 screwdriver and remove the washers.

Paso 3  ¶ 

  • Remove the four 6 mm bolts and small washers that secure the front face of the motor housing with a Phillips #3 screwdriver and remove the washers.

Paso 4  ¶ 

Pull the front face of the motor housing off toward the front of the rotor.

Paso 4  ¶ 

  • Pull the front face of the motor housing off toward the front of the rotor.

Paso 5  ¶ 

Remove the 10 mm triangular-headed bolt with a Phillips #3 screwdriver. Remove the 10 mm triangular-headed bolt with a Phillips #3 screwdriver.

Paso 5  ¶ 

  • Remove the 10 mm triangular-headed bolt with a Phillips #3 screwdriver.

Paso 6  ¶ 

Slide the back end of the motor housing away from the front of the rotor.

Paso 6  ¶ 

  • Slide the back end of the motor housing away from the front of the rotor.

Paso 7  ¶ 

Remove the small piece of paper hanging on the power button.

Paso 7  ¶ 

  • Remove the small piece of paper hanging on the power button.