Saltar al contenido principal
Ayuda

DJI Phantom 4 Advanced Electronic Speed Controller Replacement

How to replace the electronic speed controller on the DJI Phantom 4 Advanced.

  • Autor: Nicholas Allen
  • Tiempo estimado: 45 minutos - 2 horas
  • Dificultad: Muy difícil

If the motors are intact but not starting, then there is a problem with the electronic speed controller. Use this guide to replace your damaged electronic speed controller.

Secciones
Herramientas

Paso 1 Electronic Speed Controller  ¶ 

Remove the two 4 mm screws using the JIS #000 bit. Flip the metal bracket to the right and slide up.

Paso 1 Electronic Speed Controller  ¶ 

  • Remove the two 4 mm screws using the JIS #000 bit.

  • Flip the metal bracket to the right and slide up.

  • Take care when handling the metal bracket because it can easily break off.

Paso 2  ¶ 

Unlodge the glue from the board using a metal spudger.

Paso 2  ¶ 

  • Unlodge the glue from the board using a metal spudger.

Paso 3  ¶ 

Jiggle the electronic speed controller board up and away from the drone.

Paso 3  ¶ 

  • Jiggle the electronic speed controller board up and away from the drone.

Paso 4  ¶ 

Desolder the motor and LED wires on both sides of the board. For general soldering information, visit this Soldering Technique Guide.

Paso 4  ¶ 

  • Desolder the motor and LED wires on both sides of the board. For general soldering information, visit this Soldering Technique Guide.