Saltar al contenido principal
Ayuda

Hover-1 Titan Right Gyroscope Replacement

How to replace a faulty or malfunctioning gyroscope on the Hover-1 Titan.

  • Autor: Jessica Ouyang
  • Tiempo estimado: 10 - 20 minutos
  • Dificultad: Moderar

If your hoverboard will not turn on, retain a charge, move, or spin properly, use this guide to help replace your Hover-1 Titan gyroscope/motherboard.

Paso 1 Right Gyroscope and Motherboard  ¶ 

Unplug the battery from the gyroscope/motherboard by holding the yellow connector and pulling apart. Unplug the battery from the gyroscope/motherboard by holding the yellow connector and pulling apart.

Paso 1 Right Gyroscope and Motherboard  ¶ 

  • Unplug the battery from the gyroscope/motherboard by holding the yellow connector and pulling apart.

Paso 2  ¶ 

Remove four 12 mm Phillips #1 head screws from the corners of the green gyroscope/motherboard. Remove four 12 mm Phillips #1 head screws from the corners of the green gyroscope/motherboard. Remove four 12 mm Phillips #1 head screws from the corners of the green gyroscope/motherboard.

Paso 2  ¶ 

  • Remove four 12 mm Phillips #1 head screws from the corners of the green gyroscope/motherboard.

Paso 3  ¶ 

Unplug the bottom left connector by squeezing it and pulling it away from the board. Unplug the bottom left connector by squeezing it and pulling it away from the board.

Paso 3  ¶ 

  • Unplug the bottom left connector by squeezing it and pulling it away from the board.

Paso 4  ¶ 

Unplug the white wires by squeezing the connector and pulling away from the board. Unplug the white wires by squeezing the connector and pulling away from the board.

Paso 4  ¶ 

  • Unplug the white wires by squeezing the connector and pulling away from the board.

Paso 5  ¶ 

Unplug one set of the red, white, purple, and black wires by squeezing the connector and pulling away from the board. Unplug one set of the red, white, purple, and black wires by squeezing the connector and pulling away from the board.

Paso 5  ¶ 

  • Unplug one set of the red, white, purple, and black wires by squeezing the connector and pulling away from the board.

Paso 6  ¶ 

Unplug the other set of the red, white, purple, and black wires by squeezing the connector and pulling away from the board. Unplug the other set of the red, white, purple, and black wires by squeezing the connector and pulling away from the board.

Paso 6  ¶ 

  • Unplug the other set of the red, white, purple, and black wires by squeezing the connector and pulling away from the board.

Paso 7  ¶ 

Cut the cable tie and unplug the remaining wires.

Paso 7  ¶ 

  • Cut the cable tie and unplug the remaining wires.