Saltar al contenido principal
Ayuda

Bissell Pet Hair Eraser Motherboard Replacement

If you are experiencing electronic issues such as low power or no power, maybe it is time to replace your motherboard. This guide will show you how.

  • Autor: Jim Lopez
  • Tiempo estimado: 5 minutos
  • Dificultad: Moderar

The Bissell Pet Hair Erasers motherboard is accessible using this guide. This guide will show you how to replace the motherboard.

Secciones
Herramientas

Paso 1 Motherboard  ¶ 

Remove the battery plastic hold down by lifting it off the tabs. Remove the battery by lifting straight up.

Paso 1 Motherboard  ¶ 

  • Remove the battery plastic hold down by lifting it off the tabs.

  • Remove the battery by lifting straight up.

  • Position the battery aside.

Paso 2  ¶ 

Grasp the charger port and remove it by lifting it straight out of the case. Set the charger port next to the battery. Set the charger port next to the battery.

Paso 2  ¶ 

  • Grasp the charger port and remove it by lifting it straight out of the case.

  • Set the charger port next to the battery.

Paso 3  ¶ 

Remove the power button and charge LED light by gently pulling straight out of the case. The vacuum motor can be removed by pulling straight out of the case.

Paso 3  ¶ 

  • Remove the power button and charge LED light by gently pulling straight out of the case.

  • The vacuum motor can be removed by pulling straight out of the case.

  • All internals are now removed.

  • Set the case halves aside.

Paso 4  ¶ 

Remove the two 1 mm Phillips #2 screws in the shown locations.

Paso 4  ¶ 

  • Remove the two 1 mm Phillips #2 screws in the shown locations.

Paso 5  ¶ 

Disconnect the power leads from the vacuum motor. The red power lead goes on the terminal with the visible red dot.

Paso 5  ¶ 

  • Disconnect the power leads from the vacuum motor.

  • The red power lead goes on the terminal with the visible red dot.