Saltar al contenido principal
Ayuda

Dell Inspiron 1410 Hard Drive Replacement

Guía Contribuida Por Miembros

Guía Contribuida Por Miembros

Un miembro increíble de nuestra comunidad escribió esta guía. No está supervisada por el personal de iFixit.

  • Autor: Terrence15
  • Tiempo estimado: 3 - 20 minutos
  • Dificultad: Fácil

In this guide, we will show you how to remove and replace the Hard Drive.

Paso 1 Remove the Screws  ¶ 

CAUTION: Before working inside your computer, read the safety information that shipped with your computer. Follow the procedures in  Before You Begin.

Paso 1 Remove the Screws  ¶ 

  • CAUTION: Before working inside your computer, read the safety information that shipped with your computer. Follow the procedures in Before You Begin.

  • CAUTION: If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.

  • Remove the two screws securing the hard drive assembly to the system board.

Paso 2 Removing the Hard Drive Assembly  ¶ 

Holding the connector end of the hard drive assembly, pull the hard drive assembly from the system board connector.

Paso 2 Removing the Hard Drive Assembly  ¶ 

  • Holding the connector end of the hard drive assembly, pull the hard drive assembly from the system board connector.

Paso 3 Removing the Hard Drive Cage  ¶ 

Press down on the hard drive at the non-connector end slot to remove the hard drive off the hard drive cage.

Paso 3 Removing the Hard Drive Cage  ¶ 

  • Press down on the hard drive at the non-connector end slot to remove the hard drive off the hard drive cage.

Paso 4 Placing the Hard Drive  ¶ 

Place the NEW hard drive in the hard drive cage and press it down until it snaps into place.

Paso 4 Placing the Hard Drive  ¶ 

  • Place the NEW hard drive in the hard drive cage and press it down until it snaps into place.

Paso 5 Aligning the Hard Drive  ¶ 

Push down the hard drive assembly in place by aligning the hard drive connector with the system board connector.

Paso 5 Aligning the Hard Drive  ¶ 

  • Push down the hard drive assembly in place by aligning the hard drive connector with the system board connector.

Paso 6 Replace the Screws  ¶ 

Replace the two screws securing the hard drive assembly to the system board.

Paso 6 Replace the Screws  ¶ 

  • Replace the two screws securing the hard drive assembly to the system board.