Saltar al contenido principal
Ayuda

Protocol Galileo Stealth Light Emitting Diode (LED) Replacement

Replacing the Light Emitting Diode (LED) is a moderately difficult process that requires minimal tooling. Prerequisite steps are required.

  • Autor: Matthew Selting
  • Tiempo estimado: 10 - 25 minutos
  • Dificultad: Moderar

This guide will walk you through how to replace the light emitting diodes (LED) on the drone. Minimal tooling is required, but the risk of damaging the drone is greater then many of the other guides if each step is not followed and executed with extra care.

Paso 1 Light Emitting Diode (LED)  ¶ 

Remove  6mm Phillips #0 screw from the LED strip.

Paso 1 Light Emitting Diode (LED)  ¶ 

  • Remove 6mm Phillips #0 screw from the LED strip.

Paso 2  ¶ 

Remove the LED strip from the housing by applying light pressure away from the lower housing with the plastic opening tool.

Paso 2  ¶ 

  • Remove the LED strip from the housing by applying light pressure away from the lower housing with the plastic opening tool.

  • Take care not to damage the LED strip when removing it from the lower housing.

Paso 3  ¶ 

Unclip the wire plug from the motherboard by applying light pressure away from the motherboard with the plastic spudger.

Paso 3  ¶ 

  • Unclip the wire plug from the motherboard by applying light pressure away from the motherboard with the plastic spudger.

  • Avoid damaging the wire plug, wires, and motherboard when removing the wire plug.