Saltar al contenido principal
Ayuda

Protocol Galileo Stealth Housing Replacement

Separating the upper and lower housing is a simple two-step process with minimal tools required. Prerequisite steps are involved.

This guide will walk you through how to separate the upper and lower housing units of the drone. Minimal tooling is required; however, prerequisite steps are required. This guide is useful for accessing internal components of the drone.

Secciones
Herramientas

Paso 1 Housing  ¶ 

Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit. Take care to place the screws in a safe place to prevent losing them.

Paso 1 Housing  ¶ 

  • Remove the 8mm long Phillips #0 screws (24 total) from the lower housing unit.

  • Take care to place the screws in a safe place to prevent losing them.

Paso 2  ¶ 

Separate the upper and lower housing units by lightly pulling the two housing units apart.

Paso 2  ¶ 

  • Separate the upper and lower housing units by lightly pulling the two housing units apart.