Saltar al contenido principal
Ayuda

Dell Axim X30 Button Replacement

Rebanar y Trocear

Rebanar y Trocear

Los pasos de esta guía deben ser divididos y convertidos en una serie de guías de prerrequisitos.

This guide will provide step by step instruction on how to replace the buttons for the Dell Axim X30 Pocket PC.

The Dell Axim X30 has 5 buttons on the front of the device below the main screen. This guide will focus on the replacement of the home button, messaging button, navigator button, contacts button, and calendar button.

Paso 1 Buttons  ¶ 

Remove the four rubber feet with your fingers. Remove the four rubber feet with your fingers.

Paso 1 Buttons  ¶ 

  • Remove the four rubber feet with your fingers.

Paso 2  ¶ 

Insert the nylon spudger into the battery cover release slot to remove the battery from the device. Insert the nylon spudger into the battery cover release slot to remove the battery from the device.

Paso 2  ¶ 

  • Insert the nylon spudger into the battery cover release slot to remove the battery from the device.

Paso 3  ¶ 

Remove four 12.7mm JIS #0 screws.

Paso 3  ¶ 

  • Remove four 12.7mm JIS #0 screws.

Paso 4  ¶ 

Remove the back panel with a plastic opening tool. Follow the edge of the device around the entire perimeter.

Paso 4  ¶ 

  • Remove the back panel with a plastic opening tool. Follow the edge of the device around the entire perimeter.

  • The back panel will pop off easily.

Paso 5  ¶ 

Disconnect ribbon cables. You may need to use a little force to disconnect them. Disconnect red and white wired connector for speaker and motherboard battery.

Paso 5  ¶ 

  • Disconnect ribbon cables.

  • You may need to use a little force to disconnect them.

  • Disconnect red and white wired connector for speaker and motherboard battery.

Paso 6  ¶ 

Remove three 12.7mm JIS #0 screws. Remove three 12.7mm JIS #0 screws.

Paso 6  ¶ 

  • Remove three 12.7mm JIS #0 screws.

Paso 7  ¶ 

Carefully remove motherboard.

Paso 7  ¶ 

  • Carefully remove motherboard.

Paso 8  ¶ 

Remove the two 9.6 mm screws by the speaker and green battery with a JIS #0 screwdriver.

Paso 8  ¶ 

  • Remove the two 9.6 mm screws by the speaker and green battery with a JIS #0 screwdriver.

Paso 9  ¶ 

Remove black plastic board. Remove black plastic board.

Paso 9  ¶ 

  • Remove black plastic board.

Paso 10  ¶ 

Remove grey and green membrane buttons. Remove grey and green membrane buttons.

Paso 10  ¶ 

  • Remove grey and green membrane buttons.