Saltar al contenido principal
Ayuda

Dell Alienware 13 R3 Base Cover Replacement

Guía Contribuida Por Miembros

Guía Contribuida Por Miembros

Un miembro increíble de nuestra comunidad escribió esta guía. No está supervisada por el personal de iFixit.

Faltan Detalles

Faltan Detalles

Algunos de los detalles de este guía están ausentes. Ayuda a los usuarios agregando herramientas, dificultad o tiempo.

In this guide, we will show how to remove and replace the Base Cover.

  • Autor: Terrence15
  • Tiempo estimado: 4 - 20 minutos
  • Dificultad: Fácil

In this guide, we will show how to remove and replace the Base Cover.

Herramientas

Paso 1 Loosen the Screws  ¶ 

WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.

Paso 1 Loosen the Screws  ¶ 

  • WARNING: Before working inside your computer, read the safety information that shipped with your computer and follow the steps in Before Working Inside Your Computer. After working inside your computer, follow the instructions in After Working Inside Your Computer.

  • Loosen the five captive screws that secure the base cover to the computer base.

Paso 2 Pry the Base Cover  ¶ 

Using a plastic scribe, gently pry the base cover to release the tabs on the base cover from the slots on the computer base.

Paso 2 Pry the Base Cover  ¶ 

  • Using a plastic scribe, gently pry the base cover to release the tabs on the base cover from the slots on the computer base.

Paso 3 Lift the Base Cover  ¶ 

Lift the base cover off the computer base.

Paso 3 Lift the Base Cover  ¶ 

  • Lift the base cover off the computer base.

Paso 4 Disconnect the Battery Cable  ¶ 

Using a plastic scribe, disconnect the battery cable from the system board.

Paso 4 Disconnect the Battery Cable  ¶ 

  • Using a plastic scribe, disconnect the battery cable from the system board.

Paso 5 Press and Hold the Power-Button  ¶ 

No hay imagen

Paso 5 Press and Hold the Power-Button  ¶ 

  • Press and hold the power button for five seconds to ground the system board.

Paso 6 Connect the Battery Cable  ¶ 

No hay imagen

Paso 6 Connect the Battery Cable  ¶ 

  • Connect the battery cable to the system board.

Paso 7 Slide the Tabs  ¶ 

Slide the tabs on the NEW base cover into the slots on the computer base and snap the base cover into place

Paso 7 Slide the Tabs  ¶ 

  • Slide the tabs on the NEW base cover into the slots on the computer base and snap the base cover into place

Paso 8 Tighten the Five Captive Screws  ¶ 

Tighten the five captive screws that secure the base cover to the computer base.

Paso 8 Tighten the Five Captive Screws  ¶ 

  • Tighten the five captive screws that secure the base cover to the computer base.