Saltar al contenido principal

Cambios a Paso #9

Editado por Jake Devincenzi

Edicion aprobada por Jake Devincenzi

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] RemoveMove the piece of tape coveringso that it no longer covers the remaining two leads. If you are satisfied with the position of the cable relative to the pads on the board, proceed. If not, de-solder the first connection and try again.
[* black] RemoveMove the piece of tape coveringso that it no longer covers the remaining two leads. If you are satisfied with the position of the cable relative to the pads on the board, proceed. If not, de-solder the first connection and try again.
[* black] Solder the two remaining pads to the logic board, being mindful of overheating the cable or board.

Imagen 1

Ninguna imagen anterior

Añadido