Saltar al contenido principal

Cambios a Paso #7

Editado por Walter Galan

Edicion aprobada por Walter Galan

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* red] Remove four out of the outer foursix 5.3 mm T8 Torx screws holdingsecuring the hinges in placedisplay to the upper case.
[* icon_note] Do not remove the two inner-most screws just yet.
[* black] Open the device between 90 and 100 degrees, then rest it on its side.
[* red] While supporting both halves of the device with
We purposely have you leave one hand, unscrewscrew attaching the upper 5.3 mm T8 Torx screw.
[* red] Repeat the same process for the identical bottom screw.
[* icon_caution] Be sure
display to hold the display and upper case together with one hand. Failure to do so may cause the freed display/upper case to fall, potentially damaging each componentaid in future steps.
[* red] Remove four out of the outer foursix 5.3 mm T8 Torx screws holdingsecuring the hinges in placedisplay to the upper case.
[* icon_note] Do not remove the two inner-most screws just yet.
[* black] Open the device between 90 and 100 degrees, then rest it on its side.
[* red] While supporting both halves of the device with
We purposely have you leave one hand, unscrewscrew attaching the upper 5.3 mm T8 Torx screw.
[* red] Repeat the same process for the identical bottom screw.
[* icon_caution] Be sure
display to hold the display and upper case together with one hand. Failure to do so may cause the freed display/upper case to fall, potentially damaging each componentaid in future steps.

Imagen 2

Eliminado

Imagen 3

Eliminado