Saltar al contenido principal

Cambios a Paso #7

Editado por Jake Devincenzi

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* red] Remove the outer four 5.3 mm T8 Torx screws holding the hinges in place.
[* icon_note] Do not remove the two inner-most screws just yet.
[*
black] Insert wisdom hereOpen the device between 90 and 100 degrees, then rest it on its side.
[* red] While supporting both halves of the device with one hand, unscrew the upper 5.3 mm T8 Torx screw.
[* red] Repeat the same process for the identical bottom screw.
[* icon_caution] Be sure to hold the display and upper case together with one hand. Failure to do so may cause the freed display/upper case to fall, potentially damaging each component
.
[* red] Remove the outer four 5.3 mm T8 Torx screws holding the hinges in place.
[* icon_note] Do not remove the two inner-most screws just yet.
[*
black] Insert wisdom hereOpen the device between 90 and 100 degrees, then rest it on its side.
[* red] While supporting both halves of the device with one hand, unscrew the upper 5.3 mm T8 Torx screw.
[* red] Repeat the same process for the identical bottom screw.
[* icon_caution] Be sure to hold the display and upper case together with one hand. Failure to do so may cause the freed display/upper case to fall, potentially damaging each component
.

Imagen 1

Versión Antigua

Nueva Versión

Imagen 2

Versión Antigua

Nueva Versión

Imagen 3

Versión Antigua

Nueva Versión