Saltar al contenido principal

Changes to Step #1

Editado por Andrew Bookholt

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Disconnect the port hatch ribbon cable from the logic board by pulling it straight up by its black pull tab.
[* black] If necessary, pullPull the audio out ribbon cable off the adhesive securing it to the upper case.
[* black] Use a spudger to pry the audio out ribbon cable connector board off the hard drive bracket.
[* black] If necessary, pullPull the audio out ribbon cable off the adhesive securing it to the upper case.
[* black] Use a spudger to pry the audio out ribbon cable connector board off the hard drive bracket.

Imagen 3

Ninguna imagen anterior

Añadido