Saltar al contenido principal

Repara tus cosas

Derecho a reparar

Partes y herramientas

Cambios al paso #2

Editado por Walter Galan

Aprobación pendiente

Sin cambios

Líneas de Paso

[* icon_note] The next few steps require a soldering iron.
[* icon_note] The ends of the battery leads are fed through small holes in the logic board and held in place by a small amount of solder.
[* black] Begin by heating the exposed end of the white battery lead with the tip of a soldering iron while simultaneously pulling the lead away from the connection, using tweezers to grasp the lead by the insulation.
[* black] De-solder the remaining leads, following the procedure illustrated above.
[* icon_caution] Due to the delicate nature of electronic components, it is imperative to limit the amount of heat transferred from the soldering iron to the logic board. An easy way to accomplish this is to pull on the battery lead with light continuous tension while the soldering iron heats up the connection. As soon as the solder melts and the lead slides out, immediately lift the solder tip off the connection to avoid damage.

Imagen 1

Ninguna imagen anterior


Imagen 2

Ninguna imagen anterior