Saltar al contenido principal

Repara tus cosas

Derecho a Reparar

Partes y Herramientas

Cambios al paso #11

Editado por Jeff Suovanen

Edicion aprobada por Jeff Suovanen

Eliminado
Añadido
Sin cambios

Líneas de Paso

[title] Display Assembly Installation (Cont'd)
[* icon_reminder] Whether installing a replacement display assembly or re-using the existing display assembly, note the following:
[* black] Carefully straighten the digitizer and LCD data cables, and feed them through the slot cut in the outer case.
[* icon_note] The middle photo shows the digitizer cable being correctly fed through to its full length.
[* red]
[https://d3nevzfk7ii3be.cloudfront.net/igi/pOnFkdECiyCBgkjU|This photo|new_window=true] on the left shows the display assembly being installed '''incorrectly''', with a looptoo much slack in the digitizer cable, which then forms a bend/loop that gets caught in the slot of the enclosureslot. The centerthird photo also shows thethis loop.
[* icon_note] The photo on the right shows the digitizer cable being correctly fed through to its full length.

[* icon_caution] If the digitizer cable has been installed incorrectly, it will not reach its socket on the logic board. '''Do not''' attempt to pull it through by force, or it will be cut by the sharp enclosure, and tear where the loopedge of its slot in the cable joins with the thinner cable leadenclosure. Remove the display assembly, straighten the cable, and re-feed the loopcable through completely and correctly.
[* black] Carefully straighten the digitizer and LCD data cables, and feed them through the slot cut in the outer case.
[* icon_note] The middle photo shows the digitizer cable being correctly fed through to its full length.
[* red]
[https://d3nevzfk7ii3be.cloudfront.net/igi/pOnFkdECiyCBgkjU|This photo|new_window=true] on the left shows the display assembly being installed '''incorrectly''', with a looptoo much slack in the digitizer cable, which then forms a bend/loop that gets caught in the slot of the enclosureslot. The centerthird photo also shows thethis loop.
[* icon_note] The photo on the right shows the digitizer cable being correctly fed through to its full length.

[* icon_caution] If the digitizer cable has been installed incorrectly, it will not reach its socket on the logic board. '''Do not''' attempt to pull it through by force, or it will be cut by the sharp enclosure, and tear where the loopedge of its slot in the cable joins with the thinner cable leadenclosure. Remove the display assembly, straighten the cable, and re-feed the loopcable through completely and correctly.

Imagen 2

Versión Antigua

Nueva Versión

Imagen 3

Versión Antigua

Nueva Versión