Saltar al contenido principal

Repara tus cosas

Derecho a Reparar

Partes y Herramientas

Cambios al paso #4

Editado por Mike K

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* icon_caution] Only insert the spudger from the outer edge of the display assembly, and do not push it more than 6mm (1/4in) towards the inner edge of the bezel - otherwise you risk damaging a gasket between the inner edge of the bezel and the screen.
[* black] Continue working up the right side in 1"-1.5" increments:
[* yellow] Apply heat to the unreleased area.
[* red] From the outer edge of the bezel, insert the flat side of the spudger to where it snugly fits under the lifted portion of the bezel.
[* orange] '''Gently twist''' the spudger.
[* icon_caution] Only insert the spudger from the outer edge of the display assembly, and do not push it more than 6mm (1/4in) towards the inner edge of the bezel - otherwise you risk damaging a gasket between the inner edge of the bezel and the screen.