Saltar al contenido principal

Fix Your Stuff

Right to Repair

Parts & Tools

Cambios al paso #4

Editado por Mike K

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* orange] Withblack] Continue working up the flatright side in 1"-1.5" increments:
[* yellow] Apply heat to the unreleased area.
[* red] From the outer
edge of the spudger underbezel, insert the bezel and while applying heat to the area, '''gently twist'''flat side of the spudger to releasewhere it snugly fits under the double stick adhesive tape.
[* black] Continue working, in 1-1.5in segments, up the right size
lifted portion of the bezel, acrossbezel.
[* orange] '''Gently twist'''
the top, and down the left side. Do no work on the bottom edge yetspudger.
[* orange] Withblack] Continue working up the flatright side in 1"-1.5" increments:
[* yellow] Apply heat to the unreleased area.
[* red] From the outer
edge of the spudger underbezel, insert the bezel and while applying heat to the area, '''gently twist'''flat side of the spudger to releasewhere it snugly fits under the double stick adhesive tape.
[* black] Continue working, in 1-1.5in segments, up the right size
lifted portion of the bezel, acrossbezel.
[* orange] '''Gently twist'''
the top, and down the left side. Do no work on the bottom edge yetspudger.
[* icon_caution] Only insert the spudger from the outer edge of the display assembly, and do not push it more than 6mm (1/4in) towards the inner edge of the bezel - otherwise you risk damaging a gasket between the inner edge of the bezel and the screen.

Imagen 1

Versión Antigua

Nueva Versión