Saltar al contenido principal

Fix Your Stuff

Right to Repair

Parts & Tools

Cambios al paso #3

Editado por Mike K

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] On the right corner, apply heat with the heat gun for 5-10 seconds, then use a spudger to pry up
[* red] While continuing to apply heat, place the flat edge of the spuder under the bottom lip of the bezel on the lower right portion of the display assembly.
[* red] Pry
the corner of the bezelbezel upward, creating enough space to insert the flat edge of the spudger between the bezel and display assembly.
[* black] On the right corner, apply heat with the heat gun for 5-10 seconds, then use a spudger to pry up
[* red] While continuing to apply heat, place the flat edge of the spuder under the bottom lip of the bezel on the lower right portion of the display assembly.
[* red] Pry
the corner of the bezelbezel upward, creating enough space to insert the flat edge of the spudger between the bezel and display assembly.

Imagen 1

Versión Antigua

Nueva Versión