Saltar al contenido principal

Repara tus cosas

Derecho a Reparar

Partes y herramientas

Cambios al paso #3

Editado por Matt McCaffrey

Edicion aprobada por Jake Devincenzi

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Use a plastic opening tool to pull the pressure contact from underneath the battery connector.
[* icon_caution] When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils on your fingers have the potential to create wireless interference.
[* icon_caution] Take notice of the position of the small black ground clip on the upper screw of the battery connector. This clip is attached only by the upper screw. When reinstalling, it must be aligned so the gold contact point will press against the back cover.
[* icon_caution] Take notice of the position of the small black ground clip on the upper screw of the battery connector. This clip is attached only by the upper screw. When reinstalling, it must be aligned so the gold contact point will press against the back cover.
[* black] Be '''VERY''' careful not to remove the pressure contact point from the logic board. There are 4 very small soldering points awaiting this mistake!