Saltar al contenido principal

Repara tus cosas

Derecho a Reparar

Partes y herramientas

Cambios al paso #3

Editado por John Schutz

Edicion rechazada por Geoff Wacker

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Use a plastic opening tool to pullgently detach the pressure contactbattery connector from underneath the battery connector.
[* icon_caution] When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils
socket on your fingers have the potential to create wireless interference.
[* icon_caution] Take notice of
device. Start lifting off the position ofconnector from the small black ground clip onbottom side, by placing the upper screwtip of the battery connector. This clip is attached only bytool between the upper screw. When reinstalling, it must be aligned soloudspeaker enclosure and the gold contact point will press againstmetal cover of the back coverconnector.
[* blackicon_note] The battery connector comes off vertically from the logic board. Do not apply force sideways.
[* icon_caution
] Be careful not to rip off the battery connector socket soldered on the logic board. There are 4 very small soldering points awaiting this mistake!
[* black] Use a plastic opening tool to pullgently detach the pressure contactbattery connector from underneath the battery connector.
[* icon_caution] When reinstalling the pressure contact, be sure to clean it with a degreaser such as windex or isopropyl alcohol. The oils
socket on your fingers have the potential to create wireless interference.
[* icon_caution] Take notice of
device. Start lifting off the position ofconnector from the small black ground clip onbottom side, by placing the upper screwtip of the battery connector. This clip is attached only bytool between the upper screw. When reinstalling, it must be aligned soloudspeaker enclosure and the gold contact point will press againstmetal cover of the back coverconnector.
[* blackicon_note] The battery connector comes off vertically from the logic board. Do not apply force sideways.
[* icon_caution
] Be careful not to rip off the battery connector socket soldered on the logic board. There are 4 very small soldering points awaiting this mistake!

Imagen 1

Versión Antigua

Nueva Versión

Imagen 2

Versión Antigua

Nueva Versión

Imagen 3

Eliminado