Cambios al paso #1
Editado por Weston Sapusek —
Edicion aprobada por Weston Sapusek
- Antes
- Después
- Sin cambios
Líneas de Paso
| - | [* red] Use the spudger to pry up each side of the lens assembly Flat-Topped Connector at the bottom of the motherboard. |
|---|---|
| + | [* red] Use the spudger to pry up each side of the lens assembly ***Flat-Topped Connector*** at the bottom of the motherboard. |
| [* orange] Holding back the lens assembly ribbon cable, use the spudger to lift the ***Zero Insertion Force (ZIF)*** connector tab . Slide out the ribbon cable. | |
| [* icon_caution] Be sure you are prying up on the hinged retaining flap, not the connector itself. | |
| [* yellow] Use the spudger to lift the ***Zero Insertion Force (ZIF)*** connector tab located on the flash unit. Remove the ribbon cable. |