Saltar al contenido principal

Cambios a Paso #11

Editado por Steve Simmons

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Flip the frame and then rotate it 180 degrees so that the speakers are facing you.
[* icon_caution] Be careful with this sequence of steps, as the thermal sensor (and its connector) are VERY frailfragile.
[* icon_caution] Be careful with this sequence of steps, as the thermal sensor (and its connector) are VERY frailfragile.
[* black] Use a spudger to gently disconnect the thermal sensor from the hard drive.
[* black] Peel back the black tape and free the double-stranded wire from the drive.
[* black] Gently deroute the wire from the small notch on the frame (third picture).
[* icon_caution] Make sure that the thermal sensor remains connected to the interconnect board.