Saltar al contenido principal

Cambios a Paso #11

Editado por Miroslav Djuric

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Flip the frame and then rotate it 180 degrees so that the speakers are facing you.
[* icon_caution] Be careful with this sequence of steps, as the thermal sensor (and its connector) are VERY frail.
[*
black] Use a spudger to gently disconnect the three-wall connector atthermal sensor from the end of the sensorhard drive.
[* black] De-routePeel back the cableblack tape and free the double-stranded wire from the internal framedrive.
[* red] Removeblack] Gently deroute the four screws indicated bywire from the red circles in the diagramsmall notch on the third photoframe (third picture).
[* icon_caution] Make sure that the thermal sensor remains connected to the interconnect board
.
[* black] Flip the frame and then rotate it 180 degrees so that the speakers are facing you.
[* icon_caution] Be careful with this sequence of steps, as the thermal sensor (and its connector) are VERY frail.
[*
black] Use a spudger to gently disconnect the three-wall connector atthermal sensor from the end of the sensorhard drive.
[* black] De-routePeel back the cableblack tape and free the double-stranded wire from the internal framedrive.
[* red] Removeblack] Gently deroute the four screws indicated bywire from the red circles in the diagramsmall notch on the third photoframe (third picture).
[* icon_caution] Make sure that the thermal sensor remains connected to the interconnect board
.

Imagen 1

Versión Antigua

Nueva Versión

Imagen 2

Versión Antigua

Nueva Versión

Imagen 3

Versión Antigua

Nueva Versión