Saltar al contenido principal

Cambios a Paso #7

Editado por Andrew Bookholt

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* icon_caution] Important! When you reinstall a logic board, you'll need to replace the thermal paste[product|IF179-010|thermal paste] that goes between the processor on the logic board and the heat sink. Failure to remove the old paste and apply a new layer can cause the computer to overheat and sustain damage. The following steps refer to replacing the thermal paste between the processor and heat sink; follow these steps only when you are ready to place the logic board in the computer.
[* icon_caution] Important! When you reinstall a logic board, you'll need to replace the thermal paste[product|IF179-010|thermal paste] that goes between the processor on the logic board and the heat sink. Failure to remove the old paste and apply a new layer can cause the computer to overheat and sustain damage. The following steps refer to replacing the thermal paste between the processor and heat sink; follow these steps only when you are ready to place the logic board in the computer.
[* black] Use a firm plastic edge to scrape the thermal material off the heat sink .
[* black] Apply a new layer of thermal paste to the heat sink
[* icon_note] When reinstalling the Logic board, first follow the directions to remove the PCThe [guide|646|PC Card cagecage] needs to be removed before installing your new logic board. The modem cable connects underneathto the underside of the logic boardboard, connects to the modem underneath the PC Card Cage. You will need to disconnect the modem cable from the modemmodem, plug it into the bottom of the logic board, and then connectplug it back into the other end to the Logic board. Then youmodem. The PC Card cage can proceed withthen be reinstalled by following the installinstructions backwards.
[* icon_note] When reinstalling the Logic board, first follow the directions to remove the PCThe [guide|646|PC Card cagecage] needs to be removed before installing your new logic board. The modem cable connects underneathto the underside of the logic boardboard, connects to the modem underneath the PC Card Cage. You will need to disconnect the modem cable from the modemmodem, plug it into the bottom of the logic board, and then connectplug it back into the other end to the Logic board. Then youmodem. The PC Card cage can proceed withthen be reinstalled by following the installinstructions backwards.

Imagen 1

Ninguna imagen anterior

Añadido