Saltar al contenido principal

Cambios al paso #24

Editado por Evan Noronha

Edicion aprobada por Evan Noronha

Antes
Después
Sin cambios

Líneas de Paso

[* icon_note] In the next steps, you will use an iOpener to apply heat to the rear case of the iPad to soften adhesive holding the logic board in place.
[* icon_note] As you reheat and place the iOpener in each of the indicated locations, leave it in place for at least a minute to soften the adhesive through the rear case.
-[* red] The adhesive is in the form of six pieces of black foam tape—refer to this step as you work at heating and prying to keep track of where each piece is located.
+[* red] The adhesive is in the form of seven pieces of black foam tape—refer to this step as you work at heating and prying to keep track of where each piece is located.

Imagen 1

Versión Antigua

Nueva Versión