Saltar al contenido principal

Repara tus cosas

Derecho a Reparar

Partes y herramientas

Cambios al paso #2

Editado por Andrew Bookholt

Aprobación pendiente

Eliminado
Añadido
Sin cambios

Líneas de Paso

[* black] Starting with the battery cell closest to the dock connector, run a plastic opening tool underneath the edge of the battery closest to the logic board void to make enough room to insert the flat end of a spudger
[* black] Run the flat end of a spudger along the two long sides of each battery cell to completely separate them from the adhesive securing them to the rear case.
[* icon_caution] If the adhesive is very difficult to separate, reheat the rear panel and try again.

Imagen 1

Ninguna imagen anterior

Añadido

Imagen 2

Ninguna imagen anterior

Añadido