Repara tus cosas Comunidad Tienda

Cambios al paso #1

Editado por Allison —

Edicion aprobada por Allison

Antes
Después
Sin cambios

Líneas de Paso

-[* black] Using a PH0 sized screw driver, carefully remove the (length) screw from the bottom cover.
+[* black] Using a PH0 sized screw driver, carefully remove the 4mm screw from the bottom cover.
[* red] Using the plastic spudger carefully pry open the bottom cover
-[* orange] Remove the 4 (length) screws holding in the hard drive using (screwdriver type, size)
+[* orange] Remove the 3 screws holding in the hard drive using PHO screwdriver. There are two larger screws which are 3mm long, and a smaller sized screw that is 4mm in length.
[* yellow] Carefully pull on the tab on the hard drive to slide it out from the connector.
[* green] Lift up and remove the hard drive from the computer.