Saltar al contenido principal

Cambios al paso #3

Editado por JBS

Aprobación pendiente

Antes
Después
Sin cambios

Líneas de Paso

[* black] As in the previous step, use a spudger to pry the front panel up from the rear casecase, while releasing the clips with a second spudger.
[* black] Work your way
along its long edge on the volume button side of the TouchPad. Release each clip using the same method as the first one.
[* black] ContinueThe clips are shown here with red boxes. Step one also shows the locations of the clips. If needs, you can pry the edge of the rear case away from the front panel, just enough to see the clips.
[* icon_caution] Again, do not
pry the front panel assembly up alonghigh enough to see the volume button side ofclips above the TouchPad until there is a gap between it andedge of the rear case.
[* black] As in the previous step, use a spudger to pry the front panel up from the rear casecase, while releasing the clips with a second spudger.
[* black] Work your way
along its long edge on the volume button side of the TouchPad. Release each clip using the same method as the first one.
[* black] ContinueThe clips are shown here with red boxes. Step one also shows the locations of the clips. If needs, you can pry the edge of the rear case away from the front panel, just enough to see the clips.
[* icon_caution] Again, do not
pry the front panel assembly up alonghigh enough to see the volume button side ofclips above the TouchPad until there is a gap between it andedge of the rear case.

Imagen 2

Versión Antigua

Nueva Versión