Saltar al contenido principal

Cambios al paso #2

Editado por Andrew Bookholt

Aprobación pendiente

Antes
Después
Sin cambios

Líneas de Paso

[* black] Insert a flat metal spudger in the gap between the rubber outer ring on the front panel assembly and the black plastic rear case near the USB connector.
[* black] Pry the front panel assembly up from the rear case, being careful not to damage the LCD or the glass panel.
[* icon_caution] As you work through the following steps, insert your metal spudger and pry the front panel up, but do not try to slide the spudger along the gap you're creating. Always remove your spudger, then insert it at another spot and pry upward.